Barbie JAMMIN' JEEP T8396 Owner's Manual Page 7

  • Download
  • Add to my manuals
  • Print
  • Page
    / 24
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 6
7
T8396pr-0920
ELECTRICAL HAZARD
WARNING
CAUTION
BATTERY CHARGING
Battery can fall out and injure
a child if vehicle tips over.
Always use battery retainer.
PREVENT FIRE
- Never modify the electrical system.
Alterations could cause a  re
resulting in serious injury and could
also ruin the electrical system.
- Use of the wrong type battery
or charger could cause a  re or
explosion resulting in serious injury.
- Use of Power Wheels® components
in products other than Power
Wheels® vehicles could cause
overheating,  re or explosion.
The battery must be handled
by adults only. The battery is
heavy and contains sulfuric acid
(electrolyte). Dropping the battery
could result in serious injury.
Never allow children to charge the
battery. Battery charging must be
done by adults only. A child could
be injured by the electricity involved
in charging the battery.
Read the safety instructions on
the battery.
Examine the battery, charger and
their connectors for excessive wear
or damage each time you charge
the battery. If damage or excessive
wear is detected, do not use the
charger or the battery until you have
replaced the worn or damaged part.
Use the charger in dry locations only.
• Make sure you charge the battery for at least 18 hours
using the enclosed Power Wheels
®
12 volt charger
before operating your vehicle for the first time. Charge
the battery for at least 14 hours after each use of the
vehicle. Never charge the battery longer than 30 hours.
Failure to follow these instructions may damage your
battery and will void your warranty.
• Use only a Power Wheels
®
12 volt charger with “12V”
connector (input 120 VAC, 60Hz, with an output of 12
VDC) to charge your Power Wheels
®
12 volt battery.
Plug the charger connector into the battery
socket.
Plug the charger into a standard wall outlet.
Notes:
- If power flow to the wall outlet is controlled by a
switch, make sure the switch is “ON”.
- Use the charger only in a wall outlet. Do not plug
the charger into a ceiling outlet.
• Before charging the battery, examine the battery
case for cracks and other damage which may
cause sulfuric acid (electrolyte) to leak during
the charging process. If damage is detected, do
not charge the battery or use it in your vehicle.
Battery acid is very corrosive and can cause
severe damage to surfaces it contacts.
• Do not place the battery on a surface (such as
kitchen counter tops) which could be damaged
by the acid contained inside the battery. Take
precautions to protect the surface on which you
place your battery.
• Charge the battery in a well ventilated area.• Once
the battery is charged, disconnect the battery
connector from the charger connector. Unplug
the charger from the wall outlet. Refer to the
Battery Installation section for instructions on
installing your battery. If your battery is already
installed in your vehicle, simply re-connect the
motor harness connector to the battery.
• You do not need to remove the battery from your
vehicle to recharge it.
Charger
Connector
Battery must be upright while chargng
Page view 6
1 2 3 4 5 6 7 8 9 10 11 12 ... 23 24

Comments to this Manuals

No comments